INSTRUCTIONS FOR

WIRELESS BUTTON SWITCH KIT


ALL KITS COME PRE-LINKED, ONLY DO THIS TO ADD OR REMOVE SWITCHES OR CONTROLLERS

The receiver must be connected to a power source to turn on during the linking process. Once the receiver has been wired into your system, turn breaker back on to check for power before linking sensor.

  1. Press button on receiver for 3 seconds until receiver begins to toggle on/off.

  2. Press button on switch 3 times quickly to link switch to receiver, and again to unlink.

  3. The LED and output will pause ON for 3 seconds if linked, or OFF for 3 seconds if unlinked.

  4. Wait for linking mode to time out (30 seconds).

  5. Test switch to ensure it’s linked properly.


ADDITIONAL FUNCTIONS

Multi sensor/receiver systems

  • 1 sensor can connect to multiple receivers

  • Each receiver can connect to at least 10 sensors to allow for more points of control.

  • Linking instructions are the same for multiple sensors to one receiver, and multiple receivers to one sensor - see linking instructions above. 

RANGE:
50-150ft (typical)
FREQUENCY:
902 MHz
POWER SUPPLY:
SELF-GENERATED WHEN SWITCH IS PRESSED
OUTPUTS:

1 - 1A Latching Form A Relay

INPUTS:

1 - 902 MHz Wireless Antenna

MAX LOAD:

1A, General Duty: 1A 60 VDC or 30 VAC

OPERATING TEMP:

-4°F - 131°F (-20°C ~ 55°C)

DIMENSIONS:

2.42 (W) x 0.60 (H) inches

RADIO CERTIFICATION:

FCC: VJC-E9TS1RB (United States) 

RANGE:
50-150ft (typical)
FREQUENCY:
902 MHz
POWER SUPPLY INPUT RATING:
100-240VAC/60Hz
RELAY OUTPUT:

1 Form A Relay 10A

MAX LOADS / CONTACT RATINGS:

Resistive Load 10A

Tungsten 1000W

Fluorescent 600W

LED Lamp 200W

MEMORY:
Link up to 10 Switches
OPERATING TEMP:

-40°F - 104° F (-40°C - 60°C)

DIMENSIONS:

1.6(W) x 3.3(H) x 1.1(L) inches

RADIO CERTIFICATION:

FCC (United States)

CONFIRM RECEIVER IS WIRED CORRECTLY:

Test the status light on the receiver by pressing the CTRL button. Green means the output should be ON, Red means the output should be OFF. If the status light is not working, that indicates the power is not ON, wiring is incorrect, or the receiver has been damaged. If the status light turns ON, but the light doesn’t turn ON, the wiring could be incorrect or it could be a bulb failure.

CONFIRM SWITCH IS FUNCTIONAL:

Press the top of the switch to turn the receiver ON and the bottom of the switch to turn it OFF. If the receiver doesn’t respond, the switch may not be linked.