INSTRUCTIONS FOR
DOOR / WINDOW SENSOR KIT
The receiver must be connected to a power source to turn on during the linking process. Once the receiver has been wired into your system, turn breaker back on to check for power before linking sensor.
Press button on receiver for 3 seconds until receiver begins to toggle on/off.
Press button on sensor 3 times quickly to link sensor to receiver, and again to unlink.
The LED and output will pause ON for 3 seconds if linked, or OFF for 3 seconds if unlinked.
Wait for linking mode to time out (30 seconds).
Test sensor to ensure it’s linked properly.
ADDITIONAL FUNCTIONS
Multi sensor/receiver systems
1 sensor can connect to multiple receivers
Each receiver can connect to at least 10 sensors to allow for more points of control.
Linking instructions are the same for multiple sensors to one receiver, and multiple receivers to one sensor - see linking instructions above.
RANGE: | 50-150ft (typical) |
FREQUENCY: | 902 MHz |
POWER SUPPLY: | SELF-GENERATED WHEN SWITCH IS PRESSED |
OUTPUTS: | 1 - 1A Latching Form A Relay |
INPUTS: | 1 - 902 MHz Wireless Antenna |
MAX LOAD: | 1A, General Duty: 1A 60 VDC or 30 VAC |
OPERATING SPECS: | Operating Temp: 32° to +104°F (0° to +40°C) Storage Temp: -4° to +176°F (-20° to +80°C) Humidity: 10-95% non-condensing Memory Storage: 60 links |
DIMENSIONS: | 2.17 (W) x 1.87 (L) x 0.67 (H) inches |
RADIO CERTIFICATION: | FCC: VJC-E9XHSM2 (United States) |
RANGE: | 50-150ft (typical) |
FREQUENCY: | 902 MHz |
POWER SUPPLY INPUT RATING: | 100-240VAC/60Hz |
RELAY OUTPUT: | 1 Form A Relay 10A |
MAX LOADS / CONTACT RATINGS: | Resistive Load 10A Tungsten 1000W Fluorescent 600W LED Lamp 200W |
MEMORY: | Link up to 10 Switches |
OPERATING TEMP: | -40°F - 104° F (-40°C - 60°C) |
DIMENSIONS: | 1.6(W) x 3.3(H) x 1.1(L) inches |
RADIO CERTIFICATION: | FCC (United States) |