INSTRUCTIONS FOR

OUTLET RECEIVER KIT

  • 2. unscrew fixture to access wires - showing wiring diagram of neutral wires, power in and out, ground wires
  • 3. connect receiver wires to fixture wires - wiring diagram of 5 amp receiver connected to fixture wires with neutral, black, white, blue, power in and out, and ground wires
  • 2. unscrew fixture to access wires - showing wiring diagram of neutral wires, power in and out, ground wires
All kits are ready to use. Use this only if you want to add more switches and receivers.


1. Hold down both buttons until both LED lights turn green and then release them
2. Lights will then change to green + amber and begin to flash
3. Press only one end of the rocker on the RunLessWire wireless switch three times to pair
4. Unit will pause on the color green, then toggle back again to green + amber
5. Link more switches OR allow the unit to stop linking. (approx. 15 seconds)
6. After 15 seconds the indicator light will be a solid red or green, either is fine.
7. Press switch - On / Off to use
NOTE: The plug and outlet are polarized (wired), and not intended to be mated with non-polarized (wireless) devices.
POWER SUPPLY:
120VAC, 50/60Hz
POWER CONSUMPTION:
1.1W @ full load, 500mW quiescent
INPUTS/OUTPUTS:
  • Standard male plug for power input

    Standard female plug for controlled output

    1 normally open relay

    Input for accessory tabletop rocker pad

    Radio Frequency (RF) transceiver

    2 Buttons with LEADs for device configuration & manual control

MAXIMUM LOAD:
General Purpose - 15A @ 120VAC

Resistive - 15A @ 120VAC

Tungsten - 960W @120VAC

Ballast - 600W @120VAC

Motor Load Rating - 1/2 HP @ 120VAC

RF Communications:
902 MHz
TRANSMISSION RANGE:
80ft. (25m)
DIMENSIONS/WEIGHT:
4.09(H) x 1.85(W) x 1.26(D) inches

(104mm x 47mm x 32mm)

12.3oz (348g)

CORD LENGTH:
Plug cord: 3ft. (91.4cm)

Outlet cord: 1 ft. (30.5cm)

ENVIRONMENT:
  • Indoor use only
  • 32° to 131° F (0° to 55°C)
  • 5% to 95% relative humidity (non-condensing)
COMPLIANCE:
ETL Certified

902 MHz Contains:

FCC: SZV-STM300U, IC: 5713A-STM300U

RANGE:
50-150 FT (typical)
FREQUENCY:
902 MHz
POWER SUPPLY:
Self-generated when switch is pressed
OUTPUT CHANNELS:
Only limited by number of controllers in range
DIMENSIONS:
2.75(W) x 4.5(H) x 0.62(D) inches
MEMORY:
LINK UP TO 10 SWITCHES
RADIO CERTIFICATIONS:
-32° to 122° F (0° to 50° C)
ADDRESSING:
Factory set unique ID (1 of 4 billion)