INSTRUCTIONS FOR
WALL PLUG SWITCH KITS
ALL KITS COME PRE-LINKED, ONLY DO THIS TO ADD OR REMOVE SWITCHES OR CONTROLLERS
1. Pairing Wall Plug Receiver: Hold power button until blue light is flashing, or until plug makes a clicking sound (about 5 seconds)
2. Select Wireless Switch Preference:
a. Rocker Mode – (top button ON / bottom button OFF) - Press “on then off” three times (3x)
b. Momentary Mode – (power ON while switch is pressed, OFF when released) - Press and hold either top or bottom button for two seconds, then release - repeat three times (3x)
c. Toggle Mode – (each button press turns the power on and off) - Press the top or bottom button three times in a row (3x)
Linking numerous receivers to a single button is not recommended because it can make receivers get out of sync.
3. Complete Pairing: Press power button after linking action is completed to exit pairing process
MULTIPLE WALL PLUG RECEIVER / SWITCH SYSTEMS
1. 1 switch can connect to multiple receivers and each receiver can connect to up to 10 switches
2. Linking instructions are the same for multiple switches to one plug receiver, and multiple plug receivers to 1 switch - see linking instructions above
FACTORY RESET
1. Hold down power button for 10-15 seconds until it blinks 4 times (WILL NOT MAKE ANY SOUNDS)
2. Once it has blinked 4 times it is ready to pair again (see steps above)
UNLINKING INSTRUCTIONS
Do the inverse of selected switch preference. For Toggle and Momentary Modes, use the direction of the switch that isn't in use.
Unboxing and Installation
Rocker Mode
Toggle Mode
RANGE: | 30ft (10m) |
FREQUENCY: | BLUETOOTH® (BLE) (2.4Ghz) |
POWER SUPPLY: | SELF-GENERATED WHEN SWITCH IS PRESSED |
BUTTONS: | 2 BUTTONS (1 ROCKER) |
DIMENSIONS: | 2.75(W) x 4.5(H) x 0.62(D) inches |
OPERATING TEMP: | -13° to +149°F (- 25° to + 65°C) |
RADIO CERTIFICATION: | FCC (USA): SZV-PTM215U, I.C. (Canada):5713A-PTM215U |
ADDRESSING: | FACTORY SET UNIQUE IDN) |
RATED VOLTAGE: | 120VAC 50Hz/60Hz |
RATED CURRENT: | 10A Resistive 3A LED, tungsten, ¼ HP motor |
AC FREQUENCY: | 50/60Hz |
LOADS: | 10A resistive at 100-125 VAC 3A Electronic or LED Driver Loads Motor Loads: 1/4 HP Inrush current of 10A max |
IDLE POWER: | < 0.5W |
WIRELESS: | Bluetooth® (2.4GHz) |
# OF CONNECTABLE SWITCHES | 10 MAX |
DIMENSIONS: | 3.15x1.5x1.9 in (80x38x48 mm) |
OPERATING TEMP: | 14°F~104°F (-10°C~40°C) |
COMPLIANCE: | FCC (US) UL 60730 |
CONFIRM WALL PLUG RECEIVER IS FUNCTIONAL:
Test Wall plug receiver by pressing the power button. Blue light means power is on and the plug is letting power through. If the power light is not working, that indicates the power is not ON for the outlet, outlet wiring is incorrect, or the plug receiver has been damaged. If the power light does not turn on via the power button or switch - contact customer service.
CONFIRM SWITCH IS FUNCTIONAL:
Press the top button of the switch to turn the receiver ON and the bottom of the switch to turn it OFF. If the receiver doesn’t respond, the switch may not be linked.
Follow linking instructions to pair switch to plug - if problems persist contact customer service.